Checking 1st gear inner ring for wear
WARNING: This page is about a different car, the 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of VOLKSWAGEN UNITED STATES, INC.
- Check outer contact surface - arrow
- for scoring or visible traces of wear and replace if necessary.
- Press inner ring onto chamfer on selector gear and measure gap - a
- using a feeler gauge.
| Gap - a
- |
As-new installation value |
Wear limit |
| Inner ring for 1st gear |
1.2 to 2.0 mm |
0.6 mm |