Removing dual-mass flywheel
WARNING: This page is about a different car, the 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Do not use an impact wrench or pneumatic wrench to remove bolts - B - : this would severely damage the dual-mass flywheel. Bolts - B - must always be removed by hand.
- Rotate flywheel - A - so that bolts - B - are aligned centrally behind the holes - arrows -.
- When removing bolts - B - , make sure the bolt heads do not contact the flywheel - arrows - because this would damage the flywheel when the bolts are turned further.
- Removing and installing dual-mass flywheel → 13 - ENGINE - CRANKSHAFT, CYLINDER BLOCK for the appropriate engine code.