LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S4 Premium Plus, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (6-Speed Manual Transmission 01X, Front-Wheel Drive) >> 39 Final drive - differential >> Differential, removing and installing >> Differential, removing and installing >> Flange shaft assembly

Flange shaft assembly

WARNING: This page is about a different car, the 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Flange Shaft Assembly, Overview
GW00005571Courtesy of VOLKSWAGEN UNITED STATES, INC.
  1. Flange shaft
  2. Needle bearing (polygon bearing)
  3. Spacer ring
  4. Spacer ring - installed on shafts with 30mm spline diameter
  5. Circlip
NOTE:
  • The needle bearing (polygon bearing) does not turn easily when the flange shaft is removed. This does not indicate that the bearing is defective.
scientia non olet · About LEMON Manuals