Installation position of synchronizing rings for 1st and 2nd gear:
WARNING: This page is about a different car, the 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- If components are not being replaced, make sure they are re-installed on the same gear.
- Install inner ring - 2 - onto selector gear - 1 -.
- Install intermediate ring - 3 -. Lug - B - must be inserted into recess - A -.
- Synchro-ring - 4 - installed. Guide lugs - C - through recess - arrow -.