LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S4 Premium Plus, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (6-Speed Manual Transmission 01X, Front-Wheel Drive) >> 35 Gears, shafts >> Pinion shaft (output shaft) >> Pinion shaft, disassembling and assembling >> Determining thickness of circlip

Determining thickness of circlip

WARNING: This page is about a different car, the 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Determining Circlip Fit
GW00005402Courtesy of VOLKSWAGEN UNITED STATES, INC.
NOTE:
  • The thickness of the circlips for the synchronizing hubs and individual gear wheels must also be determined as shown for the tapered roller bearing.

Overview for installation position of circlips Installation position of circlips 

scientia non olet · About LEMON Manuals