LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S4 Premium Plus, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (6-Speed Manual Transmission 01X, Front-Wheel Drive) >> 35 Gears, shafts >> Input shaft, adjusting >> Determining circlips for input shaft ball bearing >> Determining thickness for circlip behind input shaft ball bearing >> The following circlips are available:

The following circlips are available:

WARNING: This page is about a different car, the 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Circlip thickness (mm)
1.54 2.08 2.62
1.63 2.17 2.71
1.72 2.26 2.80
1.81 2.35 2.89
1.90 2.44  
1.99 2.53  
Fig 1: Measuring From Thrust Washer To Contact Surface Of Housing
GW00019039Courtesy of VOLKSWAGEN UNITED STATES, INC.

Checking adjustment and checking distance "a"

The distance "a" should be 164.14mm +- 0.04 mm if the correct circlip has been selected.