Centralizing clutch plate and removing and installing pressure plate
WARNING: This page is about a different car, the 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
- Loosen and tighten bolts gradually in several stages and in diagonal sequence.
- To remove, reverse position of counter-hold tool 3067 or counter-hold tool 10 - 201.
Installation position of clutch plate: coil springs (damper assembly) or marking "Getriebeseite" point toward pressure plate and transmission.
- Before tightening securing bolts, clutch lining and contact surface of pressure plate must make full contact with flywheel.