Clutch with SAC pressure plate, removing and installing

WARNING: This page is about a different car, the 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools, testers and auxiliary items required

Fig 1: Counterhold 10-201

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Counterhold tool 10 - 201

Fig 2: Identifying Centering Mandrel 3176

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Centering mandrel 3176
Grease for clutch plate splines G000100

Fig 3: Counter-Hold Tool 10 - 201 Attached

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Attach counter-hold tool 10 - 201 before loosening bolts.

To prevent the pressure plate from becoming warped during removal (causes clutch grab when driving off), always adhere to the following procedure when unscrewing the pressure plate:

Loosen all six bolts consecutively in clockwise direction and in steps of 90° (14 turn) until the pressure plate is released.

Installing

NOTE:

Before re-installing the SAC pressure plate check that it is not warped Check SAC pressure plate for warpage, cracks and burns .
When only the clutch plate is replaced, the adjuster ring in the SAC pressure plate has to be reset before assembly → Adjuster ring in SAC clutch pressure plate, adjusting .
Installation position of clutch plate: coil springs (damper assembly) or marking "Getriebeseite" point toward pressure plate and transmission.

Fig 4: Using Centering Mandrel 3176 To Centralize Clutch Plate

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Use centering mandrel 3176 to centralize clutch plate.
Re-position counterhold tool 10 - 201 to tighten bolts.

To prevent the pressure plate from becoming warped during installation (causes clutch grab when driving off), always adhere to the following procedure when installing the pressure plate:

Position pressure plate on dowel pins.
Screw in all 6 bolts evenly by hand until bolt heads make contact with pressure plate.
Tighten all six bolts consecutively in clockwise direction and in steps of 90° (14 turn) until the housing makes contact with flywheel.
Tighten all 6 bolts to final torque (22Nm) consecutively in clockwise direction.