Pedal cluster - LHD vehicles, assembly overview

Fig 1: Pedal Cluster, Assembly Overview

Courtesy of VOLKSWAGEN UNITED STATES, INC.

1 - Mounting bracket

• Removing and installing → Master cylinder, removing and installing 

2 - Pivot pin for clutch and brake pedal

3 - Retaining clip

4 - Hex socket head bolt -25 Nm-

5 - Brake pedal

• Maintenance-free bearing, do not grease

6 - Clutch pedal switch F 36

• Removing and installing → Clutch pedal switch F36, removing and installing 
• Only installed one time
• Replace

7 - Hex socket head bolt -5 Nm-

• Secures clutch and brake pedal pivot pin

8 - Clutch pedal

• Removing and installing → Master cylinder, removing and installing 

9 - Retaining clip

10 - Retaining clip

11 - Hex socket head bolt -20 Nm-

12 - Master cylinder

• Removing and installing → Master cylinder, removing and installing 
• Gasket - arrow  - must not be removed

13 - Over-center spring

• Black side points toward clutch pedal
• Removing and installing → Over-center spring, removing and installing 

14 - Clutch pedal starter interlock switch F194

• Only for USA
• Engine can only be started when clutch is fully depressed ( clutch pedal starter interlock switch activated).
• Removing and installing
• Replace

• Only install one time

15 - Torx bolt, 25Nm

• For securing brake master cylinder/brake servo to mounting bracket