Disconnecting slave cylinder from hose/line assembly

WARNING: This page is about a different car, the 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Hydraulic Line From Slave Cylinder

GW00005234

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removing

To remove hose/line assembly, use a screwdriver to pry off clip - A - as far as stop. Only then can hose/line assembly be pulled out.

Installing

Press retaining clip - A - in as far as it will go.
Insert hose/line assembly - B - in slave cylinder and make sure that it engages audibly.
Pull on line/hose assembly to check it is secure.