Separating slave cylinder from hose/pipe assembly

WARNING: This page is about a different car, the 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Hydraulic Line From Slave Cylinder

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removing

To remove the hose/pipe assembly use a screwdriver to pry out clip -A- as far as it will go. Only then can the hose/pipe assembly be pulled out.

Installing

Push in clip -A- as far as it will go.
Insert hose/pipe assembly in slave cylinder until it clicks into position.
Check proper installation by pulling hose/pipe assembly.