Vehicles with clamp between center muffler and rear muffler
WARNING: This page is about a different car, the 2006 Audi A4, 2005 Audi A4, 2004 Audi A4, and 2003 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
- Exhaust system must be aligned when cold.
NOTE:
- It is only necessary to additionally align center muffler on vehicles with a clamp installed between center muffler and rear muffler.
- Installed position of front clamp Installed position of front clamp
- Push front section of exhaust system toward front of vehicle - arrow - until preloading at right side mounting of center muffler is - a - = 5 to 9 mm.
- Tighten bolted connections on front clamp evenly to 40 Nm.
- Push rear section of exhaust system toward front of vehicle - arrow - until preloading at rear mounting of rear muffler is a = 12 mm. Also make sure that center muffler is horizontal to bottom of vehicle (as viewed at right angle to direction of travel).
- Installed position of rear clamps Installed position of rear clamps
- Tighten bolted connections on rear clamp evenly to 40 Nm.