Crankshaft oil seal - pulley end, replacing: Installing

WARNING: This page is about a different car, the 2006 Audi A4, 2005 Audi A4, 2004 Audi A4, and 2003 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Do not oil sealing lip of oil seal.

Fig 1: Installing Guide Sleeve From 3083 Onto Crankshaft Journal

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Install guide sleeve from 3083 onto crankshaft journal.
Slide oil seal over guide sleeve.

Fig 2: Pushing In Oil Seal As Far As It Will Go Using Thrust Sleeve And Bolt From 3083

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Push in oil seal as far as it will go using thrust sleeve and bolt from 3083.
Replace bolt for toothed belt sprocket.

Fig 3: Removing Crankshaft Toothed Belt Sprocket

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Install crankshaft toothed belt sprocket. To do so, hold sprocket in position with counterhold 3415.

NOTE:

Contact surface between toothed belt sprocket and crankshaft must be free of oil.
Do not oil bolt for crankshaft toothed belt sprocket.

Install toothed belt (adjust valve timing).
Install ribbed belt and ribbed belt tensioner.
Install lock carrier → Lock carrier, moving to service position .