Centering clutch plate and removing and installing pressure plate

WARNING: This page is about a different car, the 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Centering Clutch Plate And Removing And Installing Pressure Plate

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Loosen and tighten bolts gradually over several stages in diagonal sequence - 25 Nm.
Reverse position of counterhold 3067 when removing.
Installation position of clutch plate: Spring pack (coil springs) or marking "Getriebeseite" toward pressure plate and transmission.
Do not insert mounting bolts until clutch lining and contact surface of pressure plate must make full contact with flywheel.

Use mandrel 3176 to center clutch plate.
If components are marked, assemble with white marking on dual-mass flywheel -A- aligning with white marking on pressure plate -B-.