Separating slave cylinder from hose and pipe assembly

WARNING: This page is about a different car, the 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Hydraulic Line From Slave Cylinder

GW00005234

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removing

Use a screwdriver to remove hose and line assembly, pull out clip -A- up to stop. Then the hose and pipe assembly can be pulled out.

Installing

Press in clip -A- up to stop
Insert hose and pipe assembly into slave cylinder until it is heard to engage.
Test by pulling on hose and pipe assembly.