LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S4 Premium Plus, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 173 (Gears, Shafts - S-TRONIC Transmission Internal Components 0B5 (Cabriolet)) >> 35 Gears, Shafts >> Removal And Installation >> DSG Transmission MECHATRONIC -J743- Circuit Boards >> Installing

DSG Transmission MECHATRONIC -J743- Circuit Boards: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi S5, 2014 Audi S5, 2013 Audi S5, 2012 Audi S5, and 2011 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Cross-Shaped Protector Installation Location
GWWA34-10908Courtesy of AUDI OF AMERICA, LLC

-- Install a cross-shaped protector -arrow- on the valve contacts:

  1. Sub-transmission 1 valve 3 -N435-
  2. Sub-transmission 2 valve 3 -N439-
NOTE:

Install a protector in the transmission if the transmission did not have one installed before.

-- Install a rectangular protector -arrow- on the contacts on the remaining valves:

Fig 2: Identifying Rectangular-Shaped Protector Installation Location
GWWA34-10909Courtesy of AUDI OF AMERICA, LLC
  1. Sub-transmission 2 valve 4 -N440-
  2. Main pressure valve -N472-
  3. Sub-transmission 1 valve 4 -N436-
  4. Cooling oil valve -N471-
NOTE:

Install a protector in the transmission if the transmission did not have one installed before.

-- Position the new circuit board 1 -B- carefully on the Mechatronic.

Fig 3: Circuit Board 1 - Tightening Specification And Sequence
GWWA34-10969Courtesy of AUDI OF AMERICA, LLC

-- Install the bolts -1 to 5- approximately 2 turns as a guide.

-- Push circuit board 1 carefully onto the contacts.

-- Install the bolts -1 to 5- all the way hand-tight and then tighten them to the tightening specification.

-- Position the new circuit board 2 -A- carefully on the Mechatronic.

Fig 4: Circuit Board 2 - Tightening Specification And Sequence
GWWA34-10907Courtesy of AUDI OF AMERICA, LLC

-- Install the bolts -1, 2 and 3- approximately 2 turns as a guide.

-- Push circuit board 2 carefully onto the contacts.

-- Position the wiring guide on the alignment sleeves on the small circuit board.

-- Install the bolts -1 to 5- all the way hand-tight and then tighten them to the tightening specification.

-- Connect the connectors so that they click into place. Install DSG® transmission Mechatronic -J743- DSG TRANSMISSION MECHATRONIC -J743- .