LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S4 Premium Plus, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 166 (Gears, Shafts - Manual Transmission Internal Components 0B2 AWD (Cabriolet)) >> 35 Gears, Shafts >> Disassembly And Assembly >> Output Shaft >> Removing The Roller Bearing From The Output Shaft

Removing The Roller Bearing From The Output Shaft

WARNING: This page is about a different car, the 2010 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing The Roller Bearing From The Output Shaft
GWWA35-10133Courtesy of AUDI OF AMERICA, LLC

A - Separating device 22 to 115 mm, for example Kukko 17/2

NOTE:
  • The roller bearing will get damaged when it is being removed, therefore always replace it.
  • The roller bearing cage can also get damaged when removing using a screwdriver. Then mount the separating tool on the inner race.

Install the 3rd and 4th gear wheels and the roller bearings on the output shaft.

scientia non olet · About LEMON Manuals