Flywheel And Dual Clutch Overview
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi S5, 2014 Audi S5, 2013 Audi S5, 2012 Audi S5, and 2011 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
All assembly work and tightening specifications are outlined in the "7 speed S-Tronic transmission 0B5, Servicing" repair information.
- Flywheel
- Depending on the vehicle, there are different versions; pay attention to the allocation .
- Removing and installing, refer to Removal and Installation
- Clutch Cover
- There are different versions depending on the date of manufacture, with or without a thrust washer (item: 7)
- Removing and installing, refer to Removal and Installation
- Bolt
- Tightening specification and sequence, refer to Specifications
- O-ring
- Replace
- Dual Clutch
- There are different versions depending on the date of manufacture.
- Removing and installing, refer to REMOVAL AND INSTALLATION
- Always perform the necessary "Guided Functions" on the vehicle diagnostic tester after replacing the dual clutch. Refer to TRANSMISSION GUIDED FUNCTIONS .
- Transmission Housing
- Thrust Washer
- Depending on the date of manufacture, clutch cover allocation
- Ball Bearing
- For the input shaft
- Replacing, refer to Removal and Installation
- Locking Ring
- For ball bearing
- Replace
- Locking Ring
- For the dual clutch
- Replace
- Shaft Seal
- For the input shaft
- Replacing, refer to Removal and Installation
- Bolt
- Tightening specification, refer to Specifications