Check The Plastic Washer -A- Inside The Dual Mass Flywheel Manufactured By SACHS
WARNING: This page is about a different car, the 2010 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
- The red plastic washer -A- must be inside the dual mass flywheel. It must be under the copper-colored sliding washer -B- and above the shaft seal -C-.
- If the red plastic washer -A- is missing, then the dual mass flywheel must be replaced.
- Measure the wear on the plastic washer -A-. Refer to MEASURING THE WEAR ON THE PLASTIC WASHER INSIDE THE DUAL MASS FLYWHEEL MANUFACTURED BY SACHS