Disconnecting connections
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
1 - Front seat
2 - Belt buckle sensor connector (black)
3 - Seat heater connector (green)
4 - Current supply connector (red)
5 - Airbag connector (yellow)
6 - Connector point cover
- Removal:
- Tip front seat - 1 - back.
- Remove coupling station cover - 6 - upward.
- Press in tab on airbag connector - 5 - on tunnel side and disconnect airbag connector - 5 -.
- Press in tab on connector for voltage supply - 4 - on tunnel side and disconnect connector for voltage supply - 4 -.
- Press in tab on connector for heated seat - 3 - on tunnel side and disconnect connector for heated seat - 3 -.
Vehicles with seatbelt fasten sensor:
- Press in tab on connector for seatbelt fasten sensor - 2 - on tunnel side and disconnect connector for seatbelt fasten sensor - 2 -.
All:
- Connect airbag adapter → Airbag Adapter VAS 6036, connecting .
- Remove front seat - 1 -.
- Installing:
Installation is reverse of removal.