Supercharger, Securing To Engine/Transmission Holder
WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, and 2010 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The openings on the bottom of the supercharger housing should make it possible to see and reach the charge air cooler.
Special tools and workshop equipment required
- Engine and Transmission Holder VAS 6095
- Gearbox Support T40206
Procedure
- Supercharger removed, refer to SUPERCHARGER .
-- Mount the T40206 with T40206/1 in the VAS 6095.
-- Secure the supercharger to the transmission holder as illustrated. Use the holes "1", "4", "9", "11" and "13" for the threaded connectors -1-.
-- Attach the support T40206/2 directly to the supercharger housing at the front and on the right side using the bolt -2-.
Support T40206/2 installed position:
- The seals -arrow 1- on the support must face downward.
- It is possible to see and reach the charge air cooler through the openings -arrow 2- inside the compressor housing.