Hydraulic Line On Valve Block, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Hydraulic Line, Tightening Specification

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Follow the guidelines for clean working conditions. Refer to CLEAN WORKING CONDITIONS .

-- Remove the hydraulic pump. Refer to HYDRAULIC UNIT (HYDRAULIC PUMP), REMOVING AND INSTALLING .

-- Remove the bolt -2-.

-- Remove the hydraulic line -3- from the valve block -1-.

Fig 2: Removing Connecting Piece From Cylinder

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

CAUTION:

Damage and leaks on the valve block.

The hole for the connecting piece on the hydraulic line must not be damaged.
A damaged hole will result in leaks.

-- If there is an O-ring -1- still inside the valve block, carefully remove it with a small dull hook -2-.