Power Steering System, Checking For Leaks And Fluid Level And Adding Fluid
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Hydraulic fluid G 004 000
NOTE:
The fluid level is correct only when the cap is on.
- Cold fluid (approximately 68° F (20°C):
-- With engine not running, turn the front wheels in straight-ahead position.
-- Remove the cap.
-- Clean the dipstick with clean cloth.
-- Screw cap on hand-tight and remove again.
The fluid level must be in -A- range.
- Warm fluid (approximately 176° F (80 °C)
-- Remove the cap.
-- Clean the dipstick with clean cloth.
-- Screw cap on hand-tight and remove again.
The fluid level must be in the -B- range.
NOTE:
If fluid level is above specified range, then some fluid must be siphoned off.
CAUTION:
If the fluid level is below the specified level, check the hydraulic system for leaks. It is not sufficient just to add fluid (Repair Procedure).
-- Screw in cap hand tight.