Diagnostic Data, Gathering

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

A complete execution and correct termination of the guided fault finding is necessary for gathering a complete set of data.

Do not disconnect the connection to the vehicle before finishing the procedure.

-- Connect VAS 50XX/61XX. Refer to VEHICLE DIAGNOSTIC TESTER, CONNECTING .

-- Perform the following on the diagnostic tester:

Guided Fault Finding
VIN
Perform vehicle system test

-- Continue following the tester procedure.

Before going on to Fault Finding:

GO TO
FINISH

-- Send the diagnostic log online.

-- Continue to follow the procedure on the tester until the confirmation that the online log has been sent.

NOTE:

It is necessary to have a working network connection in order to send the log online.

Any DTC memory entries are erased.