Lane Change Assistance, Preparing For Calibration
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- Calibration Tool - Spacing Laser:VAS6350/2
- For distance measurement
- For information on usage. Refer to the Calibration Tool:VAS6350 Operating Instructions.
- Calibration Tool:VAS6350
- Level
- On the Calibration Tool:VAS6350
- To check the horizontal position of the Calibration Tool:VAS6350
- Catch Bracket
- To mount the Calibration Tool - Spacing Laser:VAS6350/2 for the distance measurement
- Distance to the Calibration Tool - Wheel Center Mountings:VAS6350/1 on the rear wheels: dimension -a- = 1700 ± 2 mm
- Calibration Tool - Wheel Center Mountings:VAS6350/1
- With wheel bolt adapter and measuring paddle
- Brand Emblem
- The laser point is aligned on the center of the brand emblem
- Calibration Tool - Lane Change Calibration Tool:VAS6350/4
- is moved from one side of measuring field to the other during calibration
- when installed correctly, vehicle electrical system voltage line must be connected at bottom left of calibration tool (as seen in direction of travel)
- Measurement Scale
- For positioning the Calibration Tool - Lane Change Calibration Tool:VAS6350/4
- Calibration Tool - Linear Laser:VAS6350/3
- With "laser eye protection"
- On the Calibration Tool:VAS6350
- To turn on and off. Refer to the Calibration Tool:VAS6350 Operating Instructions.
- Plastic Foot
- Quantity: 3
- Can be adjusted for adjusting the horizontal position of the Calibration Tool:VAS6350