Lane Change Assistance Control Module -J769- /Lane Change Assistance Control Module 2 -J770-, Calibrating: Notes
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Calibration Tool:VAS6350
Conditions
-- The Lane Change Assistance Control Module -J769- /Lane Change Assistance Control Module 2 -J770- must be calibrated using the Vehicle Diagnostic Tester during the following conditions:
- Lane Change Assistance Control Module -J769- or Lane Change Assistance Control Module 2 -J770- was replaced.
- The rear bumper was damaged.
- The rear bumper cover was removed and installed.
- The DTC "no or incorrect basic setting/adaptation" is stored in the DTC memory.