Pin Assignment, Cell Phone Preparation MMI
Information Electronics Control Module 1 -J794-
- GSM connection from Telephone Antenna -R65-
- Connection block with four multi-pin connectors
- MOST bus
- CVBS input from TV Tuner -R78-
- 4-pin connector for the Front Information Display Control Head -J685-
- Multi-pin connector, 4-pin to the External Audio Source Connection -R199- /Internet Access Control Module -J666- (from MY 2012)
- Not Assigned
- Not Assigned
Unlisted connector terminals are not assigned.
2 - Connection block with four multi-pin connectors
A - Multi-Pin Connector, 8-Pin
- Not Assigned
- Power Supply to Multimedia System Control Head -E380-
- Wake UP to Multimedia System Control Head -E380-
- Not Assigned
- Switch-on signal for the Cellular Telephone Amplifier -R86-
- Res MU to Multimedia System Control Head -E380-
- Ring-break Diagnostic Cable
B - Multi-Pin Connector, 12-Pin
8 - Microphone IN (+) for the Microphone Unit in Front Roof Module -R164- (Left Front Microphone -R140-)
9 - Microphone IN (-) for the Microphone Unit in Front Roof Module -R164- (Left Front Microphone -R140-)
C - Multi-Pin Connector, 12-Pin
All pins are connected to the External Audio Source Connection -R199-.
- LF-In ground
- Right LF-In
- USB (+5V) not on the Internet Access Control Module -J666- (from MY 2012)
- USB (ground)
- Not Assigned
- Detect not on the Internet Access Control Module -J666- (from MY 2012)
- Left LF-In
- LF-In ground shielding
- CVBS cable (+)
- CVBS cable (-)
- iPod data
- iPod data
Following pins are also still connected to the Internet Access Control Module -J666- (from MY 2012).
3 - USB (+5 V)
4 - USB (ground)
6 - Detect
D - Multi-Pin Connector, 8-Pin
10 - Data from Multimedia System Control Head -E380-
11 - Data to the Multimedia System Control Head -E380-
12 - Terminal 31
13 - DIAG signal from Telephone Baseplate -R126-
14 - Res BT from Multimedia System Control Head -E380-
15 - Terminal 30
16 - Ground to Multimedia System Control Head -E380-
3 - MOST bus
- Output
- Input