Installed Calibration Tool : Vas6350 Overview
- Calibration Tool - Wheel Center Mountings :VAS6350/1
- Calibration Tool - Wheel Center Mountings :VAS6350/1
- Right angle bracket
- Calibration Tool - Spacing Laser :VAS6350/2 mount
- Plastic Foot
- Three on underside of calibration platform
- Adjustable for aligning horizontal position of calibration platform
- Calibration Tool - Linear Laser :VAS6350/3
- On the calibration board
- Switching on and off, refer to operating instructions.
- Calibration Tool - Spacing Laser :VAS6350/2
- Notes on operation, refer to operating instructions.
- Level on calibration platform
- On the calibration board
- for checking the horizontal position
- Left angle bracket
- Calibration Tool - Spacing Laser :VAS6350/2 mount
- Calibration Board
- Between the mounts on the calibration board and the Calibration Tool - Wheel Center Mountings :VAS6350/1 -dimension A- 1.47 m through 1.90 m
Calibration Board Alignment
-- Position the calibration platform behind the vehicle at a distance of 1.47 m to 1.90 m to the rear wheels, see -dimension A- in the illustration, refer to Installed Calibration Tool : VAS6350 Overview .
-- Bring the Calibration Tool :VAS6350 into a horizontal position.
-- To do so, twist plastic feet under calibration device so that air bubble in level is located exactly in the center of the indicator -arrow-.
Make sure light does not reflect off the calibration platform.
Reflections affect the Rearview Camera -R189- and may make it impossible to perform the calibration.
-- Switch on the Linear Laser :VAS6350/3A -1- on the calibration board and adjust the entire Calibration Tool :VAS6350 so that the laser beam hits the center of vehicle rear above the Audi rings.
-- Make sure the Audi rings are centered on the rear. Correct the laser beam accordingly.
Continue calibrating the Rearview Camera -R189-, refer to REARVIEW CAMERA -R189-, CALIBRATING .