Radio Connector Assignments, Chorus
- A - (AM/FM1/FM2) antenna jack
- B - Connection block with four multi-pin connectors
Unlisted connector terminals are not assigned.
A - AM/FM1/FM2 antenna jack
- Connector 2 (AM/FM1) from Antenna Amplifier -R24- (Antenna -R11-)
- Chamber 1 (FM2) from Antenna Amplifier -R24- (Radio Antenna 2 -R93-)
B - Connection block with four multipin connectors
A - Multi-Pin Connector, 8-Pin
- Right rear speaker (+)
- Right front speaker (+)
- Left front speaker (+)
- Left rear speaker (+)
- Right rear speaker (-)
- Right front speaker (-)
- Left front speaker (-)
- Left rear speaker (-)
B - Multi-Pin Connector, 12-Pin
1 - Left LF-In from the External Audio Source Connection -R199-
2 - LF-In ground from the External Audio Source Connection -R199-
7 - Right LF-In from the External Audio Source Connection -R199-
C - Multi-Pin Connector, 12-Pin
- Microphone IN (-)
- Right LF OUT
- LF OUT ground
- Microphone OUT (-)
- Left LF IN (-)
- LF (-) from the cell phone preparation/Telephone Transceiver -R36-
- Microphone IN (+)
- Left LF OUT
- Microphone OUT (+)
- LF mute wire from preliminary setup for cell phone preparation
- Left LF IN (+)
- LF (+) from the cell phone preparation/Telephone Transceiver -R36-
D - Multi-Pin Connector, 8-Pin
9 - CAN bus high (Infotainment)
10 - CAN bus low (Infotainment)
11 - Power Supply to Front Information Display Control Head -J685-
12 - Terminal 31
13 - CAN Bus (Display) to the Front Information Display Control Head -J685-
14 - CAN Bus (Display) to the Front Information Display Control Head -J685-
15 - Terminal 30
16 - Permanent positive (not used)