Rear Lid, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Unclipping Cover -1- On Hinge -3- -Arrows

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Tightening specification. Refer to OVERVIEW - REAR LID .

Install in reverse order of removal and note the following:

-- Make sure the grommet -2- fits correctly inside the rear lid.

-- Install the wiring harness cover -1-. Refer to WIRING HARNESS COVER, REMOVING AND INSTALLING .

-- Adjust the rear lid. Refer to REAR LID, ADJUSTING .

Depending on the version, the following additional work procedures are required :

-- Calibrate the Rearview Camera -R189-. Refer to REARVIEW CAMERA -R189-, REMOVING AND INSTALLING .