Overview - Hood
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- Hood
- A second technician is needed to support and hold the hood during removal and installation.
- Removing:
-- Remove the gas-filled strut from the hood. Refer to GAS-FILLED STRUT, REMOVING AND INSTALLING .
-- Remove the nuts -4- from the upper hood hinge.
-- Remove the hood.
- Install in reverse order of removal.
- Adjusting:
-- Center the hood between the fenders.
-- Adjust the height of the hood over the lower part of the hood latch.
-- Adjust the hood to the fenders using the stops Figure.
- Bolts
- 21 Nm
- Hood hinge
- For removal and installation, the hood must be removed or supported securely.
- Removing:
-- Remove the gas-filled strut. Refer to GAS-FILLED STRUT, REMOVING AND INSTALLING .
-- Remove the bolts -2- and nuts -4-.
- Install in reverse order of removal.
- Nuts
- 21 Nm
- Gas-Filled Strut
- Removing and installing. Refer to GAS-FILLED STRUT, REMOVING AND INSTALLING .
- Install with tube end of strut at body.
- Ball Pin
- 21 Nm
- Nuts
- 8 Nm
- Hook