Steering Column Electronics Control Module -J527-, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal. Note The Following:

-- Make sure all retaining hooks and connectors are engaged securely.

-- Install the steering column trim panel. Refer to OVERVIEW - STEERING COLUMN TRIM PANEL / UPPER STEERING COLUMN TRIM PANEL, REMOVING AND INSTALLING / LOWER STEERING COLUMN TRIM PANEL, REMOVING AND INSTALLING .

-- Install the steering wheel. Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING / OVERVIEW - DRIVER SIDE AIRBAG / OVERVIEW - STEERING WHEEL .

-- Install the driver airbag. Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING / OVERVIEW - DRIVER SIDE AIRBAG / OVERVIEW - STEERING WHEEL .

-- After replacing the return spring with slip ring, the steering angle sensor must be adjusted. Refer to Vehicle Diagnostic Tester.

-- If replacing the control module, select the "Replace Control Module" function on the Vehicle Diagnostic Tester.