Module Carrier With Lumbar Support Air Cushions, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Module Carrier With Air Cushions For Lumbar Support

Courtesy of AUDI OF AMERICA, LLC

-- Remove the backrest cushion. Refer to BACKREST COVER AND CUSHION, REMOVING AND INSTALLING, BUCKET SEAT .

-- Cut through the cable tie -3-.

-- Free up the wiring harness and pneumatic hose on the clip -4-.

-- Carefully detach the bonding of module carrier -2- from the backrest.

-- Tilt the upper edge of the module carrier forward -arrow- and guide out at backrest adjustment shaft -1-.

-- Remove the module carrier.