LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S4 Premium Plus, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 1360 (Seat Frames (Cabriolet)) >> 72 Seat Frames >> Front Seats >> Headrest Guide, Removing And Installing >> Headrest Guide, Removing And Installing, Standard/Sport Seat >> Installing

Headrest Guide, Removing And Installing, Standard/Sport Seat: Installing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • Follow all safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
  • Before handling pyrotechnic components (for example, connecting a connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.

Install In Reverse Order Of Removal And Note The Following: 

Headrest Guide Without Release Button: 

Fig 1: Headrest Guide Without Release Button
GWWA72-10681Courtesy of AUDI OF AMERICA, LLC
NOTE:

When Sliding The Headrest Guide -1- In, Make Sure The Tab -3- Engages Correctly On The Backrest Frame -2-.

Make sure the locking tabs -arrows- are engaged in the backrest frame -2- correctly.

Headrest Guide With Release Button: 

Fig 2: Identifying Headrest Guide With Release Button
GWWA72-10819Courtesy of AUDI OF AMERICA, LLC
NOTE:

When Sliding The Headrest Guide -1- In, Make Sure The Tab -3- Engages Correctly On The Backrest Frame -2-.

Make Sure The Locking Tabs -Arrows- Are Engaged In The Backrest Frame -2- Correctly.

Continuation For Headrest Guide Without And With Release Button

NOTE:

Make Sure The Connectors Are Installed All The Way And Engage Audibly.

WARNING:

The ignition must be on when connecting the battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone in the vehicle interior when connecting the battery.

-- Connect the battery ground cable with the ignition switched on. Refer to BATTERY, DISCONNECTING AND CONNECTING .

NOTE:

If the Airbag Indicator Lamp -K75- indicates a fault, check the DTC memory, erase it and check it again using the Vehicle Diagnostic Tester.