Seat Pan Cover And Cushion, Removing And Installing, Seat Pan With Seat Depth Adjuster: Removing
- Follow all safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
- Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.
-- Remove the front seat:
- Manual Sport Seat. Refer to FRONT SEAT, REMOVING AND INSTALLING, MANUAL .
- Power Sport seat and Super Sport seat. Refer to POWER FRONT SEAT, REMOVING AND INSTALLING .
-- Attach the front seat to the :VAS6136 . Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .
-- Remove the backrest:
- Manual Sport Seat. Refer to FRONT BACKREST, REMOVING AND INSTALLING, STANDARD SEAT/SPORT SEAT/SUPER SPORT SEAT .
- Power Sport seat and Super Sport seat. Refer to FRONT BACKREST, REMOVING AND INSTALLING, POWER STANDARD SEAT .
-- Remove the retaining bracket for the sill-side trim:
- Manual Sport Seat. Refer to RETAINING BRACKET FOR SILL-SIDE TRIM, REMOVING AND INSTALLING, MANUAL STANDARD SEAT, SPORT SEAT, SUPER SPORT SEAT .
- Power Sport seat and Super Sport seat. Refer to RETAINING BRACKET FOR SILL-SIDE TRIM, REMOVING AND INSTALLING, POWER STANDARD SEAT .
-- Versions with LATCH child seat anchor (front passenger seat only): remove the LATCH child seat anchor. Refer to FRONT CHILD SEAT ANCHOR, REMOVING AND INSTALLING .
-- Pull out the seat depth adjuster until it stops.
-- Unclip the catches -2-.
-- Tilt the support with the cushion and cover -1- for the seat depth adjuster upward in the direction of the -arrow- until the catches remain disengaged.
-- Remove the support -1- with the seat depth adjustment cushion and cover -2- upward and forward at an angle.
The illustration does not show the seat pan lower frame.
-- Disengage the tabs -3- from the holes -5- on the seat depth adjuster lower section -4-.
-- Unclip the retaining channels -1 and 2- for the cover and cushion -4- from the retainers -3- positioned diagonally at the rear and at the side.
-- Disengage the cover retaining channels -3- with the :3370 on the side areas -A- of the seat pan upper frame.
-- When disengaging the retaining channels, be careful of the protruding hooks -1- on the edge -2-.
-- Disengage both tab hooks -1- on the seat pan -3-.
- LATCH child seat anchor -2- removed.
-- Disengage the retaining channels -6- on the cover using the :3370 near -A-.
-- When disengaging the cover, be careful of the exposed hooks -4- on the edge -5-.
-- Remove the cover and cushion from the seat pan while guiding the seat heating wiring harness at the same time.
The seat depth adjuster support (plastic) remains on the cushion.