Windshield Wiper Motor -V-, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Plenum Chamber Cover

Courtesy of AUDI OF AMERICA, LLC

-- Remove the windshield wiper arms. Refer to WINDSHIELD WIPER ARMS, REMOVING AND INSTALLING .

-- Remove the bolts -3-.

-- Remove the clips -2- from the mount and remove the plenum chamber cover -1-.

-- Remove the securing clips -2- -arrow A-.

Fig 2: Locating Clips, Mounts And Plenum Chamber Cover

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

The cowl panel trim could be damaged.

Coat the space between the windshield and the cowl panel trim with some soapy water.

-- Carefully remove the cowl panel trim -1- starting at the edge of the glass vertically from the windshield -arrows B-

-- Disconnect the connector -2-.

Fig 3: Identifying Cowl Panel Trim

Courtesy of AUDI OF AMERICA, LLC

-- Remove the rain water drain channel -3- on the linkage -arrow A-.

-- Remove the bolts -4, 5 and 6-.

-- Rotate the wiper arm frame -1- with the linkage and wiper motor upward -arrow B- and pull it forward out of the plenum chamber.