Spray Nozzles, Removing And Installing [CAEB, CPMA, CPMB, CAED, CCBA, CGXC, CTUB]: Removing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Open Cover For Pray Nozzle

Courtesy of AUDI OF AMERICA, LLC

-- Remove the air intake grille. Refer to OVERVIEW - BUMPER COVER .

-- Open the cover -7- for the spray nozzle.

-- Release the spray nozzle -5- by pressing the springs -4 and 6- down using a narrow screwdriver.

-- Remove the spray nozzle from the mount -3- towards the rear -arrow-.

-- Clamp off the windshield washer fluid hose -1- with the Hose Clamps - Up To 25mm:3094 .

Fig 2: Clamping Off Washer Fluid Hose

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Lay a cloth under the coupling point to catch any washer fluid.

-- Remove the washer fluid hose -2- by pressing the release button -1-.

Fig 3: Open Cover For Pray Nozzle

Courtesy of AUDI OF AMERICA, LLC

NOTE:

If the spray nozzle cannot be removed as described (depending on the vehicle equipment), then remove the respective headlamp housing. Remove headlamp housings.

Halogen headlamps: Vehicles through MY 2011, USA through MY 2012: Refer to HEADLAMP, REMOVING AND INSTALLING, HALOGEN HEADLAMP ; Vehicles from MY 2012, USA from MY 2013: Refer to HEADLAMP, REMOVING AND INSTALLING, HALOGEN HEADLAMP .
HID headlamps: Vehicles through MY 2011: Refer to HEADLAMP, REMOVING AND INSTALLING, HID HEADLAMPS ; USA vehicles through MY 2012: Refer to HEADLAMP, REMOVING AND INSTALLING, HID HEADLAMP ; Vehicles from MY 2012, USA from MY 2013: Refer to HEADLAMP, REMOVING AND INSTALLING, HID HEADLAMP .