Headlamp Washer Pump -V11-, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Disconnecting Electrical Connector

Courtesy of AUDI OF AMERICA, LLC

-- Remove the washer fluid reservoir, but only pull it out until the Headlamp Washer Pump -V11- is accessible. Refer to WINDSHIELD WASHER FLUID RESERVOIR, REMOVING AND INSTALLING .

-- Place a drip tray under the windshield washer fluid reservoir.

-- Disconnect the connector -1-.

-- Remove the washer fluid hose -3- from the Headlamp Washer Pump -V11-.

NOTE:

There may be a clip installed rather than a hose clamp.

-- Remove the Headlamp Washer Pump -V11- -2- upward out of the washer fluid reservoir.