Overview - Cylinder Block, Belt Pulley Side, Vehicles With Hydraulic Power Steering: Notes
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi A5 Quattro, 2016 Audi A5 Quattro, 2015 Audi A5 Quattro, 2014 Audi A5 Quattro, and 2014 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
- Ribbed Belt
- Check for wear
- Do not kink
- Before removing, mark the running direction using chalk or a felt-tip pen.
- Removing and installing. Refer to RIBBED BELT, REMOVING AND INSTALLING, VEHICLES WITH HYDRAULIC POWER STEERING
- Ribbed belt routing. Refer to Figure.
- When installing, make sure it is seated correctly on the belt pulleys
- Idler Roller
- 20 Nm
- Bolt
- 150 Nm + 90°
- Always replace after removing
- Use the Counterhold - Vibration Damper :T10355 to loosen and tighten
- Coat the O-ring with engine oil
- O-ring
- Not a replacement part; supplied with the bolt -item ) OVERVIEW - CYLINDER BLOCK, BELT PULLEY SIDE, VEHICLES WITH HYDRAULIC POWER STEERING
- Vibration Damper
- With the ribbed belt pulley
- Removing and installing. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING
- Bolt
- 40 Nm
- Ribbed Belt Tensioner
- To release tension on ribbed belt, pivot using a wrench.
- Secure with the Belt Tensioner Locking Tool :T40098
- Removing and installing. Refer to RIBBED BELT TENSIONING DAMPER, REMOVING AND INSTALLING, VEHICLES WITH HYDRAULIC POWER STEERING
- Sub-Assembly Bracket
- With oil filter and engine oil cooler
- Removing and installing the sub-assembly bracket. Refer to SUB-ASSEMBLY BRACKET, REMOVING AND INSTALLING .
- Removing and installing the engine oil cooler. Refer to ENGINE OIL COOLER, REMOVING AND INSTALLING .
- Generator
- Removing and installing. Refer to GENERATOR, REMOVING AND INSTALLING .
- Bolt
- Tightening specification. Refer to OVERVIEW - GENERATOR .
- Bolt
- Tightening sequence. Refer to Figure.
- Bolt
- Tightening specification. Refer to OVERVIEW - HYDRAULIC POWER STEERING, WITH/WITHOUT DYNAMIC STEERING / OVERVIEW - POWER STEERING PUMP
- Sleeve
- Power Steering Pump
- Removing and installing. Refer to POWER STEERING PUMP, VEHICLES WITH DYNAMIC STEERING [CAEB, CPMA] / POWER STEERING PUMP, VEHICLES WITHOUT DYNAMIC STEERING [CAEB, CPMA] .
- A/C Compressor
- Do not remove or disconnect the refrigerant lines
- Removing and installing. Refer to A/C COMPRESSOR (COUPE) / A/C COMPRESSOR (CABRIOLET) .
- Bolt
- Tightening specification. Refer to A/C COMPRESSOR (COUPE) / A/C COMPRESSOR (CABRIOLET) .
- Alignment Sleeve
- For the A/C compressor
- Quantity: 2
- Bolt
- Tightening specification. Refer to OVERVIEW - HYDRAULIC POWER STEERING, WITH/WITHOUT DYNAMIC STEERING / OVERVIEW - POWER STEERING PUMP