Attachments, Removing And Installing, Except AUDI RS5: Installing
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- Tightening specification. Refer to OVERVIEW - BUMPER COVER, EXCEPT AUDI RS5 .
Install in reverse order of removal. Note the following:
-- When pressing on, make sure the end points are guided into the bumper cover before pressing on for the final time.
Trim Strip
Removing
-- Remove the lower section of the bumper cover. Refer to ATTACHMENTS, REMOVING AND INSTALLING, EXCEPT AUDI RS5 .
-- Remove the bolts -arrows-.
-- Remove the trim molding -1- forward from lower section of the bumper cover -2-.
Installing
- Tightening specification. Refer to OVERVIEW - BUMPER COVER, EXCEPT AUDI RS5 .
Install in reverse order of removal. Note the following:
-- Install the lower section of the bumper cover. Refer to ATTACHMENTS, REMOVING AND INSTALLING, EXCEPT AUDI RS5 .