Impact Member, Removing And Installing, Vehicles Through My 2011: Removing
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When installing, bring all cable ties back to same positions.
-- Remove the front bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING, EXCEPT AUDI RS5 .
-- Disconnect the electrical connector -4- on the horns and free up the electrical wiring harness -3- on the horn bracket.
-- Free up the washer nozzle water drain hose by disconnecting the cable tie -1-.
-- Remove the bolts -arrows- and the bumper cover spacer -2-.
-- Remove the impact bar -5- from the mounts.
NOTE:
Pry the impact bar out of the mounts if it is not easy to remove.