Impact Member, Removing And Installing, Vehicles From My 2012: Removing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

When installing, bring all cable ties back to same positions.

-- Remove the front bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .

-- Unclip air duct -1-, if applicable.

-- Disconnect the connector -4- from the horns.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pull the release button -5- and am free up the impact member to remove the windshield washer fluid hose -6-.

-- Remove the nuts -7- and bolts -2- upward.

-- Remove the impact bar -1- from the mounts -3-.

NOTE:

Pry the impact bar out of the mounts if it is not easy to remove.