Impact Member Mount, Removing And Installing, Vehicles Through My 2011: Removing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the front bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING, EXCEPT AUDI RS5 .

-- Remove the impact member. Refer to IMPACT MEMBER, REMOVING AND INSTALLING, VEHICLES THROUGH MY 2011 .

-- Remove the headlamp washer system spray nozzle. Refer to WINDSHIELD WASHER SYSTEM .

-- Mark the installation position of the mount to the lock carrier for installation later.

-- Remove the bolts -arrows-.

-- Remove the locating bolt -1-.

-- Tip the impact member mount -2- on the lock carrier out and remove it.

-- Remove the front bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING, EXCEPT AUDI RS5 .

-- Remove the impact member. Refer to IMPACT MEMBER, REMOVING AND INSTALLING, VEHICLES THROUGH MY 2011 .

-- Mark the installation position of the mount to the lock carrier for installation later.

-- Remove the bolts -arrows-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the locating bolt -1-.

-- Remove the impact member mount -2- on the lock carrier.