Impact Member Mount, Removing And Installing, Vehicles Through My 2011: Installing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specification. Refer to OVERVIEW - IMPACT ABSORBER, VEHICLES THROUGH MY 2011 .

Install in reverse order of removal. Note the following:

-- Tighten the impact member mount according to the marking made during removal.

-- Install the headlamp washer system spray nozzle. Refer to WINDSHIELD WASHER SYSTEM .

-- Install the impact member. Refer to IMPACT MEMBER, REMOVING AND INSTALLING, VEHICLES THROUGH MY 2011 .

-- Install the front bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING, EXCEPT AUDI RS5 .

Right Mount

Tightening specification. Refer to OVERVIEW - IMPACT ABSORBER, VEHICLES THROUGH MY 2011 .

Install in reverse order of removal. Note the following:

-- Tighten the impact member mount according to the marking made during removal.

-- Install the impact member. Refer to IMPACT MEMBER, REMOVING AND INSTALLING, VEHICLES THROUGH MY 2011 .

-- Install the front bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING, EXCEPT AUDI RS5 .