Bumper Cover, Removing And Installing, Except AUDI RS5: Removing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bumper cover. Refer to LOCK CARRIER COVER, REMOVING AND INSTALLING .

-- Disconnect the electrical connector -2- for the Outside Air Temperature Sensor -G17- and the electrical connector -1- for the front parking aid sensor.

-- Remove the bolt -3-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolt -2- and the quick-release coupling -1- on the front bumper noise insulation.

-- Remove the wheel housing liner. Refer to OVERVIEW - FRONT WHEEL HOUSING LINER, EXCEPT AUDI RS5 .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the electrical connector -1- on the fog lamp.

-- Remove the bolts -arrows-.

-- Disengage the side walls on the front side panel and remove the bumper cover forward.