Bumper Cover, Removing And Installing, AUDI RS5: Removing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the front noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Remove the bolts -arrows-.

-- Remove the front wheel housing liner. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING, AUDI RS5 .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -arrows-.

-- Remove the lock carrier cover. Refer to LOCK CARRIER COVER, REMOVING AND INSTALLING .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector -1- for the front parking aid sensor.

-- In equipped, remove the Garage Door Opener Control Module -J530- -item 2-. Refer to CONTROL MODULES .

-- Remove the bolts -arrows-.

-- Disengage the side walls on the front side panel and remove the bumper cover forward.