Battery, Removing And Installing: Installing: Procedure

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Vehicle Diagnostic Tester is attached.

-- Select the Diagnostic mode and start the diagnostics.

-- Select the tab Test Plan .

-- Select Select Individual Tests and choose the following sequence.

Body
Electrical Equipment
27 - Starter, voltage supply
Electrical Components
A - Adapt battery after replacing

The Vehicle Diagnostic Tester continues with the battery test from here on.

When the battery is connected, the following steps must be performed:

Activate the one-touch up/one-touch down power window regulators. Refer to the Owner's Manual.
Check DTC memories of all control modules and erase "Undervoltage" DTC if necessary. Refer to Vehicle Diagnostic Tester.

NOTE:

After connecting the power supply, the ABS warning lamp may only go out after the vehicle has been driven a few yards.