Adhesive Tape Surfaces

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

The vehicle must be at room temperature before the installation of self-adhesive cover, door seal molding, etc. when using adhesive tape.
The adhesive surfaces on the body must be free of dirt and grease.
Clean the adhesive surfaces using Cleaning Solution:D 009 401 04 .
Apply Bonding Agent:D 355 205 A2 on the surface on the body side using the Applicator:D 009 500 25 and let dry.
Warm the adhesive areas to approximately 40 °C (104 °F) using a hot air blower.
After installing the covers with adhesive tape, use a roller and press the adhesive tape one more time to make sure it is on securely.
After that, pull on the adhesive tape by hand just to make sure it is on.