Heater And A/C Unit Air Intake Housing, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn on the ignition.

-- Set the airflow direction to "DEF" (toward the windshield) on the Climatronic Control Module -J255- display and control head.

-- Move the passenger seats as far back as possible.

-- Turn off the ignition.

-- Remove the glove compartment. Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .

-- Remove the right footwell vent (front passenger side). Refer to FRONT PASSENGER SIDE FOOTWELL VENT, REMOVING AND INSTALLING .

-- Remove the screw clips -A- and remove the insulation mat -B-.

Fig 1: Identifying Insulation Mat Components

Courtesy of AUDI OF AMERICA, LLC

-- Remove bolts -A-.

Fig 2: Identifying Air Guide Channel Components

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the air guide to the right instrument panel vent from the instrument panel crossmember (there are different versions). Refer to INSTRUMENT PANEL CENTRAL TUBE, REMOVING AND INSTALLING .

NOTE:

The air guide from the air guide channel -B- is attached to the right instrument panel vent with two bolts. To loosen, remove the bolt which is installed at the bottom and is accessible.

-- Remove the air guide channel -B- leading to the right instrument panel vent (passenger side).

-- Detach the bracket -B- and place it to the side or remove it.

Fig 3: Disconnecting Fresh Air Blower Control Module

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -A- from the Fresh Air Blower Control Module -J126-.

-- If equipped, remove the Headlamp Range Control Module -J431- -1- (or the Cornering Lamp and Headlamp Range Control Module -J745-) and the related frame. Refer to HEADLAMP RANGE CONTROL MODULE, REMOVING AND INSTALLING .

Fig 4: Headlamp Range Control And Cornering Lamp And Headlamp Range Control Modules

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the wiring -A- from the mounting points on the air intake housing.

Fig 5: Locating Cables From Mounting Points On Air Intake Housing

Courtesy of AUDI OF AMERICA, LLC

-- Disengage locking mechanism -C- (between the A/C and the air intake housing -B-) for example, using a screwdriver -D- (lift slightly and pull in the direction of the -arrow-)

-- Pull the right side of the air intake manifold -B- downward in direction of -arrow-.

-- Mark the connector to the Airflow Door Motor -V71- -E and F- to the Recirculation Door Motor -V113- (due to the danger of confusing them with other identical connectors) and disconnect them from the actuators.

-- Loosen the upper A/C unit tab -E- from the air intake housing mount -D-.

Fig 6: Insert Both Lower Air Intake Housing Straps Into Mounting Points

Courtesy of AUDI OF AMERICA, LLC

-- Loosen both lower mounting points between the A/C unit -B- and the air intake housing -A-.

-- Remove the air intake housing.