Installation Position, Hydraulic Bonded Rubber Bushing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Installation Position, Hydraulic Bonded Rubber Bushing

Courtesy of AUDI OF AMERICA, LLC

The notch -1- is on the steering axle and faces the inside of the guide link.

The arrow -2- faces the inside of the guide link.

-- Install the hydraulic bonded rubber bushing -4- in the guide link -5- paying close attention to the installed position.

Fig 2: Identifying Hydraulic Bonded Rubber Bushing In Guide Link, Installed Position

Courtesy of AUDI OF AMERICA, LLC

-- Order the special tools as illustrated.

:V.A.G 1290A punch
:VW 412
Sleeve:VW 463/2
Hydraulic bonded rubber bushing
Guide Link
:3144
:VW 402

NOTE:

Do not tilt the hydraulic bonded rubber bushing when installing it.

-- Install the hydraulic bonded rubber bushing -4- into the guide link -5-.

-- Pay close attention to the marking -arrow-.

-- Check the press-in depth -a- of the hydraulic bonded rubber bushing inside the guide link.

Fig 3: Check Press-In Depth Of Hydraulic Bonded Rubber Bushing Inside The Guide Link

Courtesy of AUDI OF AMERICA, LLC

Dimension -a- = 18 mm.

-- If dimension -a- if not reached, then press the hydraulic bonded rubber bushing again.

-- Install the guide link. Refer to GUIDE LINK .